Replacing a Bay Lock (MK1)
Overview If you encounter a fault with the lock in the FUYL™ Locker Mk1 the process for removing and replacing that lock is more complicated that w...
Read more...FUYL
Articles in this section
Removing and Replacing the Admin Lock (MK1)
Overview This process is necessary if the small set of admin keys have been lost. As these are all keyed differently we will need to replace the ad...
Read more...Replacing a GPO unit (MK1)
Tools Required (Battery operated) Screwdriver Security Torx-Head Screwdriver bit Phillips-Head Screwdriver bit Cable Cutters 10 – 15 cable ties P...
Read more...Replacing the Pi's Power Supply (MK1)
Tools Required Torx-Head Screwdriver Phillips-Head Screwdriver Cable Cutters Cable ties Procedure Unplug the FUYL™ Locker from it's power sour...
Read more...SD Card Replacement (MK1)
Replacing the SD flash card to install new firmware Procedure Switch off power to the FUYL™ Locker. Wait at least 30 seconds before proceeding. Us...
Read more...Replacing the 12V Power Supply (MK2)
Procedure Unplug the FUYL™ Locker from it's power source and allow it to completely dissipate any power (Wait 30s). Open the Side Access Panel. En...
Read more...Replacing the 5-Way PDU (MK2)
Overview If any of the GPOs inside the FUYL™ Locker bays fail and need to be replaced we have this guide to perform this action. Procedure Unplug ...
Read more...Replacing the data cable in the FUYL™ Locker MK2
Procedure Unplug the FUYL Locker from it's power source and allow it to completely dissipate any power (Wait 30s). Open the side panel of the FUYL...
Read more...Replacing the Ethernet Cable (MK2/MK3)
Overview Your FUYL™ Locker's local functions are all controlled by a small computer located behind the Control Door (Where the PIN pad, RFID reader...
Read more...Replacing 12V Lock Cables (MK2)
Procedure Unplug the FUYL™ Locker from it's power source and allow it to completely dissipate any power (Wait 30s). Open the Maintenance Access Pa...
Read more...Troubleshooting No Lock Comms Error (MK1)
Symptoms If the FUYL™ Locker is not functioning properly and you are seeing the no lock comms error on the screen then please check the following. ...
Read more...Replacing FUYL™ MK1 Hinge Boxes
Tools needed: Electric drill Long nose pliers Vice grips Rivet gun Procedure Lay the FUYL Locker on its back, locate the Hinge rod retention pla...
Read more...Replacing FUYL Bay Locking Modules (MK2/MK3)
Overview The FUYL Lock Modules are specifically designed to be user replaceable at the request of our support team. The following guide assumes no ...
Read more...Replacing the 24V Power Supply
Overview This describes the process of replacing the 24V Power Supply (PSU) in the FUYL Tower 15 Pro (MK3). Replacing the PSU and wiring harness is...
Read more...Installing Stuck Lock Fix
Overview In rare cases, some MK3 locks may experience the manual release pin or lever getting stuck on the edge of the lock component's metal casin...
Read more...